29
Chapter 5
Telephony
3. Click Register New DECT Handset and follow instructions on the page to register
your DECT handset.
5. 2. 2. Configuring DECT Settings
Configure DECT settings on the web management page of the modem router.
Follow the steps below to configure:
1. Visit http://tplinkmodem.net, and log in with the password you set for the router.
2. Go to Advanced > VoIP > DECT, and you will see the following screen.
3. Click to enable or disable the DECT function. (Enabled by default).
4. The PIN code is needed when registering your cordless phone. The default is 0000.
Change it by entering a new one.
5. Reduce DECT field strength: Check the box to enable this function. In this mode,
base transmit power will be decreased. Then the DECT Handset will have signal
within a small distance.
6. Eco DECT: Only when all handsets support Eco Mode, will it take effect. In this
mode, if all the handsets standby for more than one minutes, DECT Base and
To Next Page
Loading...
