TP-Link JetStream T2700G-28TQ - RP Mapping

258
Priority: Specify the prior
ity of the candidate RP. The default value is
192.
Interval:
Specify the interval of advertisement message of the
candidate RP in seconds. The default value is 60.

PIM SM Candidate RP Table
Interface: Displays the VLAN interface of the candidate RP.
Priority: Displays the priority of the candidate RP.
Interval: Displays the interval of the candidate RP.
Next advertisement
time:
Displays the remaining time to send the next RP
advertisement packet.
11.4.5 RP Mapping
Choose the menu Multicast Routing→PIM SM→RP Mapping to load the following page.
Figure 11-24 RP Mapping
The following entries are displayed on this screen:

Search Option
Search Option:
 ALL: Select All to display all entries.
 Group: Select Group and e
nter the group IP address of
desired entry.
 RP
: Select RP and enter the RP IP address of desired
entry.

Group to RP Mappings Information
Group: Displays the group address.
RP: Displays the RP address.
Info Source: Displays the BSR address which announce
the RP
information.
Priority: Displays the priority of the RP.
Holdtime: Displays the holdtime of the RP.
Expires
Displays the expiry time of the RP. If RP is static, the expiry
time will be Never.