TP-Link JetStream T2700G-28TQ - Page 277

265
Step Operation Note
3
Enable IGMP Required. On page Multicast Routing→IGMP→Interface Config,
enable the IGMP function on VLAN interface 100.
4
Configure static
multicast routing
Required. On page Multicast Routing→Static Mroute→Static
Mroute Config
, configure a static multicast routing entry with the
Source as 50.1.1.100, the Sour
ce Mask as 255.255.255.0 and the
RPF Neighbor as 20.1.1.2.
 Configure Switch C
Step Operation Note
1
E
nable IP
multicast routing
Required. On page Multicast Routing→Global Config→Global
Config, enable the Multicast Routing function globally.
2
Enable PIM DM Required. On page Multicast Routing→PIM DM→PIM DM Interface,
enable PIM DM on the VLAN interfaces 101 and 103.
3) Verify the configuration
On page Multicast Routing→Global Config→Mroute Table on Switch A, check the RPF
neighbor of the entry whose Source is 50.1.1.100/24. The RPF neighbor should be 20.1.1.2 (the
interface on Switch C) if the configuration is valid.
Return to CONTENTS