25
Chapter 6
Telephony
6. 1. Connecting the Telephone
Connect your telephone to the TAE ports or RJ11 ports on the side panel. Note that the
RJ-11 and TAE ports cannot be connected simultaneously.
RJ-11
PHONE2
PHONE1
TAE
PHONE2
PHONE1
OR
Connect your telephone to the RJ-11 port of
the modem router.
Or connect your telephone to the TAE port of
the modem router.
6. 2. DECT
The modem router is integrated with DECT (Digital Enhanced Cordless
Telecommunications) function. With this function enabled, you can register your
cordless phone on the modem router and make calls via internet.
6. 2. 1. Registering DECT Handset
There are two ways to register your DECT handset.
Method 1: Via DECT Button
1. Set your DECT handset in the registration mode, and then press and hold the DECT
button on the DSL router for about 3 seconds until the Phone LED
flashes.
DECT
Blinking
DECT
Within 1 minute Press for 3 seconds
2. Enter the PIN (Default: 0000) on the DECT handset if required.
Notes:
1. Up to six DECT handsets can be registered on the modem router and up to 4 DECT handsets can make or receive
calls simultaneously.
2. If you press the DECT button for more than 4 seconds, and the Phone LED still does not light, release the button and
try again. If the problem persists, please reboot the modem router and try again.
To Next Page
Loading...
