4.12 IPv6 Route Settings
Choose “IPv6 Route Settings”, it includes two menus: IPv6 Default Gateway and IPv6 Static
Route. The detailed descriptions are provided below.
4.12.1 IPv6 Default Gateway
Choose “IPv6 Route Settings”“IPv6 Default Gateway”, you can see the Default Gateway
screen. You can select a WAN Interface from the drop-down list as the system default gateway.
Figure 4-68
Click the Add Interface button, you can add WAN Interfaces.
Click the Save button to save your settings.
4.12.2 IPv6 Static Route
Choose “IPv6 Route Settings” “IPv6 Static Route”. You can see the IPv6 Static Route screen.
This screen allows you to configure the IPv6 static routes (shown in Figure 4-69). An IPv6 static
route is a pre-determined path that network information must travel to reach a specific host or
network.
Figure 4-69
To add a new entry, follow the instructions below.
1. Click the Add New button in Figure 4-69, and you will see the screen as shown in Figure
4-70.
77
To Next Page
Loading...
