Configuring Transmission NAT Configurations
Configuration Guide
59
Interface Specify the effective interface for the rule.
Source IP Range Specify the source IP range for the rule.
Status Check the box to enable the rule.
Description Give a description for the rule entry to facilitate your management.
2) Click OK.
2.2 Configuring the One-to-One NAT
Note:
TL-R470T+ does not support One-to-One NAT.
Choose the menu Transmission > NAT > One-to-One NAT and click Add to load the
following page.
Figure 2-2 Configuring the One-to-One NAT
Follow these steps to configure the One-to-One NAT:
1) Specify the name of the One-to-One NAT rule and configure other related parameters.
Interface Specify the effective interface for the rule.
Original IP Specify the original IP address for the rule. The original IP address cannot be the
broadcast address, network address or IP address of the interface.
Translated IP Specify the translated IP address for the rule. The translated IP address cannot be
the broadcast address, network address or IP address of the interface.
DMZ Forwarding Check the box to enable DMZ Forwarding. The packets transmitted to the
translated IP address will be forwarded to the host of original IP address if DMZ
Forwarding is enabled.
To Next Page
Loading...
