Configuring Transmission Routing Configurations
Configuration Guide
71
Metric Define the priority of the route. A smaller value means a higher priority. The default
value is 0. It is recommended to keep the default value.
Description Enter a brief description for the rule.
Status Check the box to enable the rule.
6.2 Configuring the Policy Routing
Choose the menu Transmission> Routing > Policy Routing and click Add to load the
following page.
Figure 6-2 Configuring the Policy Routing
Specify the name of the policy routing entry and configure other related parameters. Then
click OK.
Name Enter a name for the policy routing entry.
Service Type Specify the service type for the rule.
Source IP Enter the source IP range for the rule. 0.0.0.0 - 0.0.0.0 means any IP is acceptable.
Destination IP Enter the destination IP range for the rule. 0.0.0.0 - 0.0.0.0 means any IP is acceptable.
WAN Specify the effective port for the rule.
Effective Time Specify the effective time for the rule.
Description Enter a brief description for the rule.
Status Check the box to enable the rule.
To Next Page
Loading...
