Configuring Transmission Configuration Examples
Configuration Guide
73
7
Configuration Examples
7.1 Example for Configuring NAT
Note:
This example for configuring NAT is only suitable for TL-R480T+.
7.1.1 Network Requirements
A company has two departments: Market Department and RD department. Each
department is assigned to an individual subnet. The company has the following
requirements:
1) The two departments need to access the internet via the same gateway router.
2) The company has a web server which needs to be accessed by the users on the
internet.
7.1.2 Network Topology
Figure 7-1 Network Topology
Internet
L3 Switch
Web Server
Gateway Router
RD Department
172.16.10.0/24
Market Department
172.16.20.0/24
WAN1
LAN
192.168.0.10
192.168.0.20
123.1.1.3
7.1.3 Configuration Scheme
To meet the first requirement, add Multi-nets NAT entries for the two departments
respectively on the gateway router, thus the router can translate and deliver packets
whose source IP addresses are in different subnets from the router’s LAN IP segment.
To Next Page
Loading...
