5
Chapter 1
Get to Know About Your GPON Router
Some Common LEDs Explanation
LED Status Indication
(Power)
On The system is starting up or has started up successfully.
Flashing
The system is rebooting or the firmware is being upgraded. Do
not disconnect or power off your router.
Off Power is off.
(GPON)
On The router is registered with the ISP.
Flashing The router is trying to register with the ISP.
Off The router is not yet registered with the ISP.
(LOS)
On The router is unable to transmit optical signal.
Flashing No optical signal is received or the received signal is too weak.
Off The router is receiving optical signal properly.
(Internet)
On Internet service is available.
Flashing The router is transmitting or receiving data.
Off The router’s WAN port is unplugged.
(2.4GHz Wireless)
On The 2.4GHz wireless band is enabled.
Flashing The router is transmitting or receiving data via 2.4GHz band.
Off The 2.4GHz wireless band is disabled.
(5GHz Wireless)
On The 5GHz wireless band is enabled.
Flashing The router is transmitting or receiving data via 5GHz band.
Off The 5GHz wireless band is disabled.
(WPS)
On/Off
Turns on when a WPS synchronization is established and
automatically turns off about 5 minutes later.
Flashing
A wireless device is trying to connect to the network via WPS.
This process may take up to 2 minutes.
(WAN)
On A device is connected to the WAN port.
Flashing The WAN port is sending or receiving data.
Off No device is connected to the WAN port.
(LAN)
On A device is connected to the LAN port.
Flashing The LAN port is sending or receiving data.
Off No device is connected to the LAN port.
To Next Page
Loading...
Need help?
General
