Assembly Instructions | ILM Servo Kits
10 Edition 03/2021 EN
Safety
2 SAFETY
These instructions contain notes that you must follow for your own personal safety and
to avoid injury and damage to property. They are highlighted by warning triangles and
are shown as follows according to the level of danger.
2.1 Hazard classification
DANGER
The signal word designates a hazard with a high degree of risk which, if it is not avoided,
will result in death or severe injury.
WARNING
The signal word designates a hazard with a medium degree of risk which, if it is not avoid-
ed, will result in death or severe injury.
CAUTION
The signal word designates a hazard with a low degree of risk which, if it is not avoided,
could result in minor or moderate injury.
NOTE
A note as used in these instructions contains important information about the product or
about a part of the manual to which particular attention should be paid.
2.2 Target group
The activities described in this manual must only be carried out by technicians with the
following qualifications:
— Training in the installation and commissioning of electrical devices (qualified elec-
trician as defined in EN 50110–1: a person with technical training, knowledge and
experience sufficient to allow them to recognise and avoid the risks that might be
posed by electricity)
— Extensive knowledge in the fields of electrical engineering and drive technology
— Training in electrical and mechanical hazards and the local safety requirements
— Knowledge of the relevant standards and directives
— Knowledge and observance of this document and all the safety instructions
Any employee who does not have the relevant training must be given appropriate
training and instruction. The instruction is to be given by authorised personnel with the
appropriate training.
To Next Page
Loading...
Need help?
General