Assembly Instructions | ILM Servo Kits
11Edition 03/2021 EN
Safety
2.3 Intended use
The ILM servo kits must be used only for the applications listed in the technical descrip-
tions, i.e. as a structurally-integrated drive. Any different or more extensive usage will be
regarded as contrary to the intended use and will invalidate the warranty.
The ILM servo kits are regarded as "partly-completed machinery" as defined in the
Machinery Directive 2006/42/EC and must not be brought into service until it has been
determined that the machines in which the ILM servo kits are to be installed conform to
the provisions of the Machinery Directive 2006/42/EC.
The ILM servo kits are not domestic appliances; as components they are intend-
ed exclusively for reuse for commercial or professional purposes as defined by
IEC/EN 61000–3–2.
Intended use also includes compliance with this manual and the instructions it contains.
If the ILM servo kits are to be used safely and without interruption, they must have been
correctly transported, stored, assembled and set up.
For any use contrary to the intended use, TQ-Systems GmbH shall accept no liability for
any damage that may occur and offers no warranty that the product will work perfectly
and correctly.
2.4 Working environment and operation
The ILM servo kits must only be operated under the conditions of use and within the
performance limits specified in the documentation.
The ILM servo kits are not permitted to be used in the following areas:
— in potentially explosive areas
— in areas in which harmful substances as defined in EN 60721 may be encountered,
such as oils, acids, gases, vapours or dusts
— underwater
— in areas exposed to radiation
— in a vacuum
To Next Page
Loading...
Need help?
General