Assembly Instructions | ILM Servo Kits
8 Edition 03/2021 EN
Introduction
1.6 Explanation of the symbols used
► This symbol indicates an action to be taken.
— This symbol indicates a list.
1.7 Training
The manufacturer offers training courses on the general handling of the ILM servo kits.
Please contact the TQ-Drives division of TQ-Systems GmbH as required.
1.8 Declaration of incorporation
The ILM servo kits are regarded as "partly-completed machinery" as defined in the
Machinery Directive 2006/42/EC. The declaration of incorporation is an integral part of
this installation manual (see section 8 on page 26).
1.9 Serial number
— The serial number is shown on the label attached to the stator.
— There is a tape with label and serial number attached to the rotor.
1.10 Warranty
TQ-Systems GmbH guarantees that, if used for the agreed purpose, the ILM servo kits
fulfil the contractually defined specifications and functionality and correspond to the
state of the art at the time of delivery.
The warranty is limited to material, manufacturing and processing defects.
The manufacturer’s liability and warranty shall not apply in the following cases:
— Genuine parts were not replaced with genuine parts or parts approved by
TQ-Systems GmbH.
— The assembly or set-up work was carried out without following these assembly
instructions or was otherwise carried out incorrectly.
— Unauthorized repairs
— Incorrect operation
— Incorrect use
— Application of force
— Other modifications to the contractual product
NOTE
The warranty period is 12 months and starts upon delivery to the customer.
Please contact the TQ-Drives division of TQ-Systems GmbH for all claims under the
warranty.
To Next Page
Loading...
Need help?
General