Assembly Instructions | ILM Servo Kits
9Edition 03/2021 EN
Introduction
1.11 Transportation and storage
— The stator and rotor of the ILM servo kit are shipped in separate packing units.
— Always transport the ILM servo kits in the original packaging to avoid mechanical
damage or damage due to static electricity.
— During transportation, avoid hard impacts or vibrations that could affect the
ILM servo kits.
1.12 Environmentally-friendly disposal
DANGER
Danger of death by powerful magnetic fields.
The life of persons with passive or active implants such as pacemakers, defibrillators, insu-
lin pumps etc. is put at risk if they stand in the vicinity of the ILM servo kit.
► Make sure that no persons who could possibly be affected by powerful magnetic fields
are able to approach the ILM servo kit. They must maintain a safe distance of at least
2 m.
► Instruct persons in the vicinity of the potential risk.
The ILM servo kits must not be disposed of in the residual waste bin.
► In Germany, metal and plastic components should be disposed of at the local recy-
cling centre. The national regulations in other EU states should also be followed.
► In Germany, electrical components should be disposed of in accordance with the
Electrical and Electronic Equipment Act (ElektroG). In other EU states, the na-
tional implementation of the Waste Electrical and Electronic Equipment Directive
2002/96/EC (WEEE) should be followed.
► The regulations and statutory requirements in your own country concerning disposal
should also be followed.
1.13 Trademarks
— HYSOL® is a trademark of Henkel.
— LOCTITE® is a trademark of Henkel.
— Kapton® is a trademark of DuPont.
To Next Page
Loading...
Need help?
General