To Next Page

To Previous Page

Assembly Instructions | ILM Servo Kits

23Edition 03/2021 EN

Assembly

► Cure the adhesive for approx. 10 minutes in the curing oven. Make sure that no ex-

cess adhesive can bond to the ﬂoor of the curing oven.

► Attach the 0.9 mm dispensing needle to the disposable syringe.

► Fill the disposable syringe (e.g. with LOCTITE 9497).

► Inject adhesive into the hole (item 2 in Fig. 12) in the housing until the adhesive

emerges from the hole on the opposite side. Twist the needle a little from side to

side as you inject to evenly distribute the adhesive.

► Remove the adhesive that emerges and seal both holes with Kapton tape.

► Place the stator in the curing oven so that it cures fully. Follow the manufacturer’s

instructions concerning time and temperature.

Questions and Answers:

Need help?

Do you have a question about the TQ ILM Series and is the answer not in the manual?

TQ ILM Series Specifications

General