Figure 34: Removal of the external panel
Applying the sealing strip
The supplied self-adhesive sealing strip (Figure 35) has to applied on the inner edge of the section
flange, refer to Figure 36.
Figure 36: Applying the sealing strip
For roof units as well as at device separations directly before or after a wet area (e.g. cooler, hu-
midifier, air washer), special actions for sealing the AHU must be carried out by using the supplied
sealing agent (Sikaflex). Further information will follow in chapter 5.1.5 (Special features for roof
units and device separations at wet areas).
Figure 37: Sealing agent (Sikaflex)
Figure 38: Applying the sealing agent
To Next Page
Loading...
