ASHRAE Guideline 3 Report
6 CVHE-CLD-1A
* Displays are not in any sequence. Some displays will never appear, depending on options and situation
Active Chilled Water Setpoint/Chilled Water
Setpoint Source
Settings source will be one of the following: Front
Panel, Tracer, or External Source.
Active Current Limit Setpt/Current Limit Setpt
Source
Settings source will be one of the following: Front
Panel, Tracer, External Source, or Ice Building.
Refrigerant Monitor
The following item will be displayed if the Analog Rfgt
Monitor is installed.
The following item will be displayed if the IPC Rfgt
Monitor option is installed.
Where (Y) can equal 123, 11, 22, 134a, or 12.
Purge Pumpout Rate/Purge Max Pumpout Rate
The following screen(s) does not appear if the
selected Purge Control/Type is “Stand-Alone Purge.”
Run
Unit Is Running; Base Loaded
Current Based Soft Loading
Run-Ice Build
Unit Is Building Ice
Capacity Limited By High Cond Press
Unit Is Running In Minimum Capacity Unit Is Building Ice
Capacity Limited By Low Evap Temp
Unit Is Running In Minimum Capacity
Time Remaining: MIN:SEC
Unit Is Building Ice
Surge Has Been Detected
Run-Unload
Unit Is Preparing To Shutdown Ice Building Is Complete
Run-Ice Build
Unit Is Building Ice
Capacity Limited By Vane Open Travel
Stop
Unit Is Running; Transitioning Ice Building
To Normal MIN:SEC
Unit Is Building Ice
Post-Lube
Post Lubrication
Time Remaining: MIN:SEC
Unit Is Building Ice
Capacity Limited By High Current
Stop
Panic Stop
Unit Is Building Ice
Capacity Limited By Phase Unbalance
Starter Dry Run
Unit Operation
Operating Mode Display*
(First Line/Second Line) Unit Operation
Operating Mode Display*
(First Line/Second Line)
Active Chilled Water Setpoint: xxx.x f/c
[settings source] CWS: xxx.x f/c
Active Current Limit Setpoint: xxx %
[settings source] CLS: xxx %
Refrigerant Monitor: xxx.x PPM
Press (Next)(Previous) To Continue
Refrigerant Monitor: xxxx PPM R-YYYY
Press (Next)(Previous) To Continue
Purge Pumpout Rate: xxx.x Min/24Hrs
Purge Max Pumpout Rate: xxx.x Min/24Hrs