Chiller Report
10 CVHE-CLD-1A
Chiller Report
The Chiller Report sequence is as follows:
Chiller Operating Mode
Friendly mode line 1 is indicative of a unit mode.
Friendly mode line 2 is usually a verbal continuation
of line 1 and can be viewed as a continuous
message along with line 1. In some cases Friendly
mode line 2 is the display of an associated timer or
system parameter.
[Friendly mode] will be one of the following:
Chiller Status, Water Temps & Setpts
Press (Next)(Previous) To Continue
Friendly mode line 1
Friendly mode line 2
Friendly Mode (First Line/second Line)
Display is Blank
Resetting
Local Stop: Cannot Be Overridden By
Any External Or Remote Device
Remote Display Stop: Chiller May Be
Set To Auto By Any Ext Or Rmt Device
Remote Run Inhibit From Remote Computer
Remote Run Inhibit From External Source
Remote Run Inhibit From Tracer
Run Inhibit From DCM
Heat Sink Temperature Start Inhibit
Diagnostic Shutdown Stop
Diagnostic Shutdown Auto
Auto
Waiting For Evaporator Water Flow
Auto
Waiting For A Need To Cool
Auto
Waiting For A Need To Heat
Waiting For Tracer Communications
To Establish Operating Status
Starting Is Inhibited By Staggered Start
Time Remaining: MIN:SEC
Transitioning To Free Cooling
Waiting For Cond Water Flow
Opening Free Cooling Valves
Cond Water Is Flowing
Closing Free Cooling Valves
Unit Running; Last Mode Free Cooling Limit
Time Remaining To End Of Limit: MIN:SEC
Transitioning To Free Cooling
Waiting For IGV Positioning To Complete
Unit Is Free Cooling
Starting Is Inhibited By Restart
Inhibit Timer: Time Remaining MIN:SEC
Establishing Cond Water Flow
Establishing Oil Pressure
Establishing Cond Water Flow
PreLubrication Time: MIN:SEC
Cond Water Is Flowing
Establishing Oil Pressure
Starting
Unit Is Running
To Next Page
Loading...
Need help?
General
