RT-SVP04F-EN 33
System Operating Status
Condenser Sump Pump Relay Command: ON Used With: All IntelliPak II units
with water-cooled condensers
installed.
Possible Values: Sump Pump
Relay: ON, OFF; Sump Proving:
FLOW, NO FLOW
Condenser Sump Pump Proving: FLOW
1. Pressing the NEXT key will scroll forward through the screens.
2. Pressing the PREVIOUS key will scroll backwards to view the
previously displayed screen.
3. Press the NEXT key until the following screen is displayed.
(if applicable)
Condenser Water Valve Relay Ckt1: OFF Used With: All IntelliPak II units
with water-cooled condensers
installed.
Possible Values: Water Valve
Relay: ON, OFF; Water Valve:
CLOSED, OPEN
Condenser Water Valve Ckt1: OPEN
1. Pressing the NEXT key will scroll forward through the screens.
2. Pressing the PREVIOUS key will scroll backwards to view the
previously displayed screen.
3. Press the NEXT key until the following screen is displayed.
(if applicable)
Condenser Water Valve Relay Ckt2: ON Used With: All IntelliPak II units
with water-cooled condensers
installed.
Possible Values: Water Valve
Relay: ON, OFF; Water Valve:
CLOSED, OPEN
Condenser Water Valve Ckt2: CLOSED
1. Pressing the NEXT key will scroll forward through the screens.
2. Pressing the PREVIOUS key will scroll backwards to view the
previously displayed screen.
3. Press the NEXT key until the following screen is displayed.
(if applicable)
Condenser Sump Fill Relay: OFF Used With: All IntelliPak II units
with water-cooled condensers
installed.
Possible Values: Sump Fill Relay:
ON, OFF; Sump Fill Valve: CLOSED,
OPEN
Condenser Sump Fill Valve: OPEN
1. Pressing the NEXT key will scroll forward through the screens.
2. Pressing the PREVIOUS key will scroll backwards to view the
previously displayed screen.
3. Press the NEXT key until the following screen is displayed.
(if applicable)
Condenser Sump Drain Relay: ON Used With: All IntelliPak II units
with water-cooled condensers
installed.
Possible Values: Sump Drain
Relay: ON, OFF; Sump Drain Valve:
CLOSED, OPEN
Condenser Sump Drain Valve: CLOSED
1. Pressing the NEXT key will scroll forward through the screens.
2. Pressing the PREVIOUS key will scroll backwards to view the
previously displayed screen.
3. Press the NEXT key until the following screen is displayed.
(if applicable)
Note: Valve position with Relay ON is configurable based on if need
to hold water in the sump or drain it on power loss. See
Installation and Operations Manual.
To Next Page
Loading...
