EasyManuals Logo

Trane Tracer ZN517 User Manual

Trane Tracer ZN517
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Chapter 1 Overview and specifications
4 CNT-SVX12C-EN
Storage environment
If you are storing a Tracer ZN517 unitary controller for a substantial
amount of time, store it in an indoor environment that meets the
following requirements:
Temperature: From –40° to 185°F (–40° to 85°C)
Relative humidity: From 5–95%, noncondensing
Agency listing/compliance
CE—Immunity: EN50082-2:1995
EN61000-6-2:1999
CE—Emissions: EN61000-3-2:1995
EN61000-3-3:1995
EN50081-1:1992 (CISPR 22)
EN55011:1998, Class B
UL and C-UL 916 listed:
Energy management equipment
UL 94-5V (UL flammability rating for plenum use)
FCC Part 15, Class A, CFR 47
Factory default temperature setpoints
The Tracer ZN517 unitary controller relies on a number of temperature
setpoints to control HVAC equipment. Table 1 gives the factory defaults
for these setpoints, which can all be edited with the Rover service tool or a
BAS.
Table 1. Factory default temperature setpoints
Setpoints
Factory defaults
°F (°C)
Default setpoints
Occupied cooling 74.0°F (23.3°C)
Occupied standby cooling 78.0°F (25.6°C)
Unoccupied cooling 85.0°F (29.4°C)
Occupied heating 71.0°F (21.7°C)
Occupied standby heating 67.0°F (19.4°C)
Unoccupied heating 60.0°F (15.6°C)
Occupied setpoint limits
Cooling setpoint high limit 110.0°F (43.3°C)
Cooling setpoint low limit 40.0°F (44.4°C)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Trane Tracer ZN517 and is the answer not in the manual?

Trane Tracer ZN517 Specifications

General IconGeneral
BrandTrane
ModelTracer ZN517
CategoryController
LanguageEnglish

Related product manuals