Chapter 2 Mounting the controller
8 CNT-SVX12C-EN
Mounting recommendations
Mounting recommendations are as follows:
IMPORTANT
Mount the Tracer ZN517 unitary controller with the cover on to avoid
the possibility of damaging the circuit board during installation.
• Mount the controller in any direction, other than with the front of the
cover facing downward.
• Mount using the two
3
/
16
in. (4.8 mm) radius mounting holes provided
(see Figure 3). Mounting fasteners are not included.
• Attach the controller securely so it can withstand vibrations of associ-
ated HVAC equipment.
• When the controller is mounted in a small enclosed compartment,
complete all wiring connections before securing the controller in the
compartment.
Figure 3. Mounting the Tracer ZN517 unitary controller
To Next Page
Loading...
