WPS: Place a check in this box to enable this feature.
WPS Current Status: Displays the current status of the WPS configuration.
Self Pin Code: Displays the current PIN.
SSID: Displays the current SSID.
Authentication Mode: Displays the current authentication mode.
Passphrase Key: Displays the current passphrase.
Interface: Displays the current interface.
WPS Via Push Button: Click on the Start to Process button if you would like to enable WPS
through the Push Button instead of the PIN. After pressing this button you will be required to press
the WPS on the client device within two minutes. Click on the OK button in the dialog box.
WPS via PIN: Specify a PIN, which unique number that can be used to add the router to an existing
network or to create a new network. Then click on the Start to Process button.
Apply: Click on the button to save the changes.
Client List
This screen displays all wireless client’s currently connected to the access point.
VLAN
This feature is only available under AP mode and allows users to configure the VLAN settings of the
access point.
To Next Page
Loading...
Need help?
General
