Configure FTP ALG Config
Advanced > NAT > FTP ALG Config
File Transfer Protocol (FTP) is a common protocol for exchanging files over IP networks.
1. Log into your modem router management page (see “Access your modem router
management page” on page 23).
2. Click on Advanced, click on NAT, and click on FTP ALG Config
3. Enter the port number in FTP ALG port and click on Add Dest Ports to save the port.
4. To remove a port from the FTP ALG Ports Table, select the port you wish to remove
and click Delete Selected DestPort button.
Configure NAT IP Mapping
Advanced > NAT > NAT IP Mapping
Setting up NAT IP Mapping will allow remote access to your network with a specific IP
address.
1. Log into your modem router management page (see “Access your modem router
management page” on page 23).
2. Click on Advanced, click on NAT, and click on NAT IP Mapping.
3. Select the Type of NAT IP Mapping from the drop down menu.
4. Review and input the settings below and Apply Changes to save the settings.
• Local Start IP: The start of the IP address range in your network
• Local End IP: The end of the IP address range in your network
• Global Start IP: The start of the public IP address that you are accessing from
• Global End IP: The end of the IP address range that you are accessing from
5. To delete a setting that was setup, select the rule you wish to delete under Action
and click Delete Selected, or to delete all the rules click Delete all.
Additional Security Settings
Advanced > DoS Settings
To provide additional security, your router offers Anti-Attack feature. You may want to
enable these features for additional network security.
1. Log into your modem router management page (see “Access your modem router
management page” on page 23).
2. Click on Advanced and click on DoS Settings.
3. Select Enable DoS Prevention to activate mode.
4. A complete list of added protection will appear. Select items to enable protection and
click Apply Changes to save settings.
To Next Page
Loading...
Need help?
General
