Using 3G WAN Connection
Your router’s USB port can be used to connect a 3G USB dongle for 3G WAN connection.
This can be beneficial when you have access to only a 3G WAN internet
Configure 3G WAN
Advanced > Network Tools > 3G Backup
In most cases once the 3G USB dongle is plugged into one of the USB ports the required
3G WAN settings would automatically generate. However, if you are still having issues,
you can manually enter required settings. Please contact your 3G ISP (Internet Service
Provider) for more information. Please note it may take up to 2 minutes for the device
to establish connection with your 3G network.
1. Log into your router management page (see “Access your router management page”
on page 23).
2. Click on Advanced, and click on 3G WAN Configuration.
3. Click Enable 3G WAN to have the device automatically input required settings. Click
Apply to save settings.
Router Maintenance & Monitoring
Reset your router to factory defaults
Maintenance > System
You may want to reset your router to factory defaults if you are encountering difficulties
with your router and have attempted all other troubleshooting. Before you reset your
router to defaults, if possible, you should backup your router configuration first, see
“Backup and restore your router configuration settings” on page 45.
There are two methods that can be used to reset your router to factory defaults.
• Reset Button: Located on the front panel of your router, see “Product
Hardware Features” on page 2 . Use this method if you are encountering
difficulties with accessing your router management page.
OR
• Router Management Page
1. Log into your router management page (see “Access your router management page”
on page 23).
2. Click on Management, and click on System.
To Next Page
Loading...
Need help?
General
