© Copyright 2015 TRENDnet. All Rights Reserved.
Wizard
1. For the first time logging into the device the setup wizard will start automatically.
2. Your security the first step is to change the login password of the access point. Enter
your new login password and click OK.
3. Your new password settings will be applied and you will be redirected to the login
screen. You will need to use the new login password to proceed.
Using the utility
For additional information on the utility please go to software controller section.
1. Insert the CD ROM included with the access point.
2. Click on Software controller to install the utility.
3. Once the utility is installed click on Discover to refresh the list of access points.
4. Select the access point you want to configure.
To Next Page
Loading...
Need help?
General
