static IP address to the device or use DHCP reservation to ensure the IP address of
the device does not change.
• Comment – Enter a name or description for the port forwarding rule.
Click the icon to a new port forwarding rule.
Note: You can delete a port forwarding entry by clicking icon next to the entry.
Example: To forward TCP port 80 to your IP camera
1. Setup DynDNS service (see Identify Your Network).
2. Access TRENDnet IP Camera management page and forward Port 80 (see product
documentation)
3. Make sure to configure your network/IP camera to use a static IP address.
Note: You may need to reference your camera documentation on configuring a static IP
address.
4. Log into your router management page (see “Access your router management page”
on page 23).
5. Click on Firewall and click on Port Forwarding.
6. Check the Enable Port Forwarding option..
7. Enter the IP address assigned to the camera in the Local IP field. (e.g. 192.168.10.101)
8. The Local Port and Public Port, enter port number 80 for both settings.
9. Make sure TCP is selected in the Type drop-down list.
10. To save changes to this section, click Apply at the bottom of the page when finished.
To Next Page
Loading...
Need help?
General
