1. Log into your router management page (see “Access your router management page”
on page 23).
2. Click on Tools and on click Firmware Upgrade.
3. Depending on your web browser, in the Upload Firmware section, click Browse or
Choose File.
4. Navigate to the folder on your computer where the unzipped firmware file (.bin) is
located and select it.
5. Click Upload. If prompted, click Yes or OK.
Reset your router to factory defaults
Advanced > Administrator > Settings Management
You may want to reset your router to factory defaults if you are encountering difficulties
with your router and have attempted all other troubleshooting. Before you reset your
router to defaults, if possible, you should backup your router configuration first, see
“Backup and restore your router configuration settings” on page 59.
There are two methods that can be used to reset your router to factory defaults.
• Reset Button – Located on the side panel of your router, see “Product Hardware
Features” on page 2. Use this method if you are encountering difficulties with
accessing your router management page.
OR
• Router Management Page / TRENDnet Mesh App
1. Log into your router management page (see “Access your router management page”
on page 23).
2. Click on Tools and on click Backup / Restore.
3. Next to Reset to Defaults, click Perform reset. When prompted to confirm this action,
click OK.
Note: This will reset all mesh network nodes to factory defaults.
To Next Page
Loading...
Need help?
General
