TR Engineering Ltd recommend the use of a buffer tank. Buffer tanks (direct
cylinders) can achieve the optimum running of the system in terms of efficiency and
running costs.
Once the plumbing has been completed the system should be fully flushed to clear any
debris which may have become lodged in the pipe work. The system must then be filled
and the pump can be run continuously for a few hours to completely de-aerate the
system. Only when the system has been fully vented can the boiler be commissioned.
25
The installation and the design of the central heating system must be in accordance
with BS EN 14336:2004: Heating Systems in Buildings. Installation and commissioning
of water based heating systems. BS EN 12828: 2003; Heating Systems in Buildings.
Design of water based heating systems. BS EN 12831: 2003; Heating Systems in
Buildings. Method for calculation of the design heat load.
To Next Page
Loading...
