5.6.1.5 Monitor
Menu allows you to view the values as read by the system sensors.
5.6.1.6 Load Menu
Menu allows you to load the auger manually.
To enable the auger select ON
To stop the auger select OFF or wait 600 seconds. (The seconds of activation are
showed on the display)
IT IS POSSIBLE TO LOAD THE AUGER MANUALLY ONLY IF THE SYSTEM IS
OFF.
NOTE: ONLY RUN THE AUGER WHILE THE PLASTIC FLEXI-PIPE IS
DISCONNECTED FROM THE PELLET FEED PIPE.
5.6.1.7 Language Menu
This menu allows you to change the language version on the display.
38
To Next Page
Loading...
