TRIMOS SA Av. de Longemalle 5 CH 1020 Renens Switzerland
Tel ++ 41 21 633 01 01 Fax ++41 21 633 01 02 office@trimos.ch http://www.trimos.ch
Page 9
7. Getting started
The instrument stands on a granite surface table
(or e.i. cast Iron table)
- Switch ON the instrument by pressing the key (ON).
- The display will show
- The reference of the column must be taken :
- Move the probe (A) slowly and cross
the two arrows to take the reference.
This operation will memorized this
reference point improve
the accuracy of the instrument.
- The display will begin to count.
If during this operation the display
doesn’t count.
restart the operation again.
- If the indicator (36) showing complete
battery discharge, connect the AC
adaptor. The instrument remains
opérational.
Complete recharging takes 15 hours.
- It will not do any harm by connecting the AC adaptor
continiously, because it will charge the instrument with
a maintenance power.
IT IS NOT NECESSARY TO WAIT FOR THE INSTRUMENT TO BE
FULLY CHARGED BEFORE USE :
INSTRUMENT CAN BE USED DURING CHARGE CYCLE.
A
rEF I
MM
0.125
MM
MM
0.125 B
To Next Page
Loading...
Need help?
General
