Triton AMORE User Manual

21
USER OPERATING INSTRUCTIONS
10
SECTIONSECTION
NOTE: In normal use, it is in order to leave the
water supply permanently on to the shower
unit, but as with most electrical appliances, the
unit MUST be switched off at the isolating
switch when not in use.
Fig.20
Temperature Temperature
control knobcontrol knob
To adjust the shower temperature - Eco
and Max settings only (g.20)
• The water temperature is changed by increasing
or decreasing the flow rate of the water through
the shower via the temperature control knob.
• After obtaining your showering temperature,
the knob can be left as the normal setting
and should only need altering to compensate
for seasonal changes in ambient water
temperature.
NOTE: The preferred knob position on ECO will
give a different temperature to the same position
on MAX.
To decrease the shower temperature
• Turning the temperature control knob
anti-clockwise will increase the flow of
water through the shower and make the
water colder. The screen will display the
temperature.
To increase the shower temperature
• Turning the temperature control clockwise
will decrease the flow of water through the
shower and make the water hotter. The
screen will display the temperature.
NOTE: It is advisable that the showering
temperature is tested with your hand before
stepping under the showerhead.
IMPORTANT
After any adjustment has been made, it will
take a few seconds for the temperature to
stabilise and reach the showerhead.
h
o
t
t
e
r
c
o
l
d
e
r

Triton AMORE Specifications

General

Type	Electric Shower
Start/Stop Button	Yes
Phased Shutdown	Yes
Warranty	2 years
Cable Entry Points	Bottom
Material	Plastic
Finish	White