7
ARK 100 can be used as a stereo headset when plugged into PC via USB. However, if you would like to
configure the audio response, and use the surround sound feature, the product software application will need
to be downloaded and installed.
1. Make sure the PC is powered on.
2. Plug the USB cable into the back of the headset.
3. Plug the other end of the USB cable into an available port.
4. Windows will briefly install generic drivers for the ARK 100. It will then function as a USB headset.
To make sure Windows is correctly configured, go to Control Panel > Sound.
Click on the Playback tab. Next, right-click the ARK 100 entry and set it to the default device, and the default
communication device.
To Next Page
Loading...
Need help?
General
