EasyManuals Logo

Triumph Sprint ST User Manual

Triumph Sprint ST
130 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
42
General Information
Seat - Sprint GT
1. S e a t l o c k
The seat lock is located on the left hand side
of the battery tray, in line with the footrest
mounting rail. To remove the seat, insert the
ignition key into the seat lock and turn it
anti-clockwise while pressing down on the
rear of the seat. This will release the seat from
its lock and allow it to be slid rearwards for
complete removal from the motorcycle.
To re-install the seat, engage the seat's two
front hooks under the fuel tank, engage the
center hooks under the rear subframe bridge
and slide the seat fully forwards. Press down
at the rear to engage in the seat lock.
Seat Care
To prevent damage to the seat or seat cover,
care must be taken not to drop or lean the
seat against any surface which may damage
the seat or seat cover.
Warning
To prevent detachment of the seat during
riding, after installation always grasp the
seat and pull firmly upwards. If the seat is
not correctly secured, it will detach from
the lock. A loose or detached seat could
cause loss of motorcycle control and an
accident.
cgdi
1
Caution
To prevent damage to the seat or seat
cover, care must be taken not to drop the
seat. Do not lean the seat against the
motorcycle or any surface which may
damage the seat or seat cover. Instead,
place the seat, with the seat cover facing
upwards, on a clean, flat surface which is
covered with a soft cloth.
Do not place any item on the seat which
may cause damage or staining to the seat
cover.

Table of Contents

Other manuals for Triumph Sprint ST

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Triumph Sprint ST and is the answer not in the manual?

Triumph Sprint ST Specifications

General IconGeneral
Engine TypeLiquid-cooled, 12 valve, DOHC, in-line 3-cylinder
Displacement1050cc
Bore x Stroke79 x 71.4 mm
Compression Ratio12.0:1
Fuel SystemMultipoint sequential electronic fuel injection
Final DriveX ring chain
ClutchWet, multi-plate
Gearbox6-speed
Rear SuspensionMonoshock with adjustable preload and rebound damping
Rear BrakesSingle 255mm disc, 2-piston caliper
Front Wheel17 x 3.5 in
Rear Wheel17 x 5.5 in
Front Tyre120/70 ZR 17
Rear Tyre180/55 ZR 17
Max Power125 PS / 123 bhp / 92 kW @ 9, 250 rpm
Max Torque104 Nm / 77 ft-lb @ 5, 000 rpm
FrameAluminum beam perimeter
Front Suspension43 mm
Front BrakesTwin 320 mm floating discs, 4 piston calipers
Seat Height805 mm
Dry Weight210 kg
Fuel Tank Capacity20 liters

Related product manuals