Trolex XD1+ - 12.2 Other Operating Modes

D1
+
PERSONAL DUST MONITOR32
12.2 ‘In-cab’ mode
The D1
+
‘In Cab’ mode allows for the same operating
functionally as ‘Normal’ mode, however, it allows the
particulate sensor and device warnings to remain active
when connected or powered via USB interfaces which
allows the device to be continuously used in a vehicle.
This mode is indicated via the solid illumination of the
battery symbol during operation as highlighted.
The D1
+
will turn itself o after 5 minutes after USB
power has been removed to save power.
12.3 ‘Data log’ mode
The D1
+
‘Data log’ mode follows the operational
functionality of ‘Normal’ mode, but readings are not
checked against alarm threshold levels and on-device
warnings / alarms will not trigger.
This mode is intended for use during passive monitoring
of environments where data is captured for download
and post-analysis using the BreatheLITE software.
This mode is indicated via 2 turquoise illuminated icons
as highlighted.
12.4 ‘Live readout’ mode
The ‘Live readout’ mode allows the D1
+
to stream live
particulate data to the BreatheLITE software via USB
connection.
Particulate data is also logged to the internal memory
for download and analysis as required.
This mode is indicated by 2 violet illuminated icons as
highlighted.
XD1+_User manual_P5650.1600_Rev A