Safety
2.1.3 Residual risk
Even if all safety regulations are observed, a residual risk remains when operating the machine.
The measures required to reduce all residual risks can be found in the following paragraphs of the chapter "Safety".
2.1.4 Machine modification
It is strictly prohibited to alter, refit or modify the machine in any way without the express consent of the manufacturer.
Likewise, it is strictly prohibited to remove, bridge or bypass any safety devices. Operating conditions and connection
and setup values stated in the data sheet must be complied with at all times.
Operation of the system is permitted only with original parts and accessories by the manufacturer. Use of third-party
parts affects machine safety.
2.1.5 Operating modes
NORMAL OPERATION
For normal operation the following conditions must be met:
•
Intended use of the machine (see chapter "Intended use").
•
Operation of the machine only by trained personnel.
•
Full functional and mounted safety devices.
•
Machine must be in technically flawless condition.
•
Processing of permissible materials according to the material list.
•
Maintenance and service are not included.
Notice
During normal operation it is not necessary to wear safety glasses.
SERVICE OPERATION
Service activities may be carried out only by authorized, trained service technicians. If side panels as well as covers get
removed and safety devices get bypassed, it can lead to direct and indirect scattered radiation. The service operation is
therefore declared as laser class 4 (US: class IV) and proper precautions need to be taken (see "Laser classification").
2.1.6 Applicable safety regulations
The following directives and guidelines must be observed to avoid hazards when operating Trotec laser systems:
14
To Next Page
Loading...
Need help?
General
