What does Fault CN01 mean on a True Treadmill?
If your True Treadmill displays Fault CN01: Internal Fault, power cycle the treadmill, re-configure the console, or re-install the software/firmware. Contact dealer or TRUE service.
What is Fault CN04 on True ALPINE RUNNER Treadmill?
If your True Treadmill displays Fault CN04: Lower Board Comm Fault (Treadmill Only), power cycle the treadmill, and check the cable connections. Contact dealer or TRUE service.
What does Fault CN00 mean on my True ALPINE RUNNER Treadmill?
If your True Treadmill shows Fault CN00: Corrupted Console Configuration, power cycle the treadmill, re-configure the console, or re-install the software/firmware. If the firmware and software versions are not compatible, re-install software/ firmware. Contact dealer or TRUE service.
What does Fault SP04: No Speed Signal mean on my True ALPINE RUNNER?
Fault SP04 on your True Treadmill indicates there is no speed signal. This can be caused by high belt deck friction or low line voltage. Lubricate the treadbelt and check the AC line voltage.
What does Fault A103: Motor Controller Fault mean on my True Treadmill?
Fault A103 on your True Treadmill indicates a motor controller fault. This may be due to a loose cable. Check cable connections.
What does Fault A111: Motor Controller Fault mean on my True Treadmill?
Fault A111 on your True Treadmill indicates a motor controller fault. This may be due to high belt deck friction or low line voltage. Lubricate the treadbelt and check the AC line voltage.
What does Fault A121: Motor Controller Fault mean on my True ALPINE RUNNER Treadmill?
Fault A121 on your True Treadmill indicates a motor controller fault. This may be due to a loose cable connection. Check cable connections.
How to fix a True ALPINE RUNNER with no power?
If your True Treadmill has no power, first, ensure the On/Off switch is in the ON position. Then, check the power cord at both the unit and the outlet to make sure it's fully plugged in. Next, use a voltmeter to verify that the outlet has power. Finally, check the circuit breaker located next to the On/Off switch to ensure it hasn't tripped; if it has, reset it. If the power cord is damaged, replace it.
What to do if my True ALPINE RUNNER is making a rubbing sound when in operation?
If you hear a rubbing sound from your True Treadmill during operation, it could be that the walking belt is rubbing against a straddle cover. In this case, adjust the belt tracking. See Chapter 5: Centering the Running Belt. Alternatively, a foreign object may be stuck under the walking belt. Inspect under the unit and remove any object that you find.
What to do if my True Treadmill walking belt is off center?
If your True Treadmill walking belt is off center, it might be due to an uneven floor. Adjust the treadmill using the rear leveling feet. Also, you may need to adjust the belt tracking. See Chapter 5: Centering the Running Belt.
Key safety warnings and instructions for users to follow before operating the equipment.
Detailed instructions on proper electrical grounding to prevent shock hazards.
Information on voltage, circuit requirements, and plugs for safe power connection.
Essential tasks for maintaining the treadmill to ensure longevity and void warranty issues.
Procedure for reporting any damage to the product incurred during shipment.
A guide to diagnose and resolve common malfunctions and error codes for the treadmill.
Details of the commercial limited warranty, coverage, terms, and claims procedure for the treadmill.
To Next Page
General
