Truma CP plus - Safety instructions; Safety instructions for the control panel

4
34020-01385 · 00 · 07/2022
EN
Intended use Truma CP plus
2 Intended use
2.1 Proper use
The CPplus
1
is used to control and monitor a Combi
heater and/or a Truma air conditioning system� The
CPplus
1
acts as an interface to operate connected
appliances via the Truma App and iNet Box�
The CPplus
1
is intended for installation in caravans and
motor homes�
2.2 Inappropriate use
Installation in boats is not permitted�
3 Safety instructions
3.1 General safety

Read and closely follow safety instructions to pre-
vent risks and damage for people and property�

Read and observe the operating instructions and
supporting documents for the appliances, such as
gas supply, heater, air conditioning system and the
vehicle carefully and keep them in a safe place for
subsequent use�

Observe local laws, guidelines and standards associ-
ated with the use and operation of the device�
3.2 Safety instructions for the control
panel

The CPplus must not be operated unless it is in tech-
nically perfect condition�

Repairs must be carried out immediately� Do not
attempt to rectify malfunctions yourself unless this
is described in the troubleshooting guide of these
instructions�

Do not repair or modify the CPplus�

A faulty CPplus may be repaired only by the manu-
facturer or the manufacturer’s service department�

Never use LP gas appliances when refuelling, in mul-
ti-storey car parks, in garages or on ferries� Switch
off the CPplus to prevent the heater being switched
back on by the Truma App or the time switch (see
“Switching on/off”)�
1
or CPplus CI-BUS for CI-BUS – cannot be retrofitted�