Truma CP plus User Manual

22
34020-01385 · 00 · 07/2022
EN
Special displays Truma CP plus
Appliance
C = Truma CPplus
F = CPplus CI-BUS
A = Air conditioning system
H = Heater
T = Truma iNet Box
Default setting (RESET)
The reset function resets the CP plus to the default
setting� This deletes all settings� Newly connected appli-
ances are detected and stored in the Truma CPplus�
•
Switch on the power supply, 12 V for Truma CPplus
and Combi and 230 V for an air conditioning system
and Combi E�
Reset

Select “RESET” with the rotary push button�

Press the rotary push button�

“PR SET” is displayed

Press the rotary push button to confirm�
After confirmation, the CPplus initialises itself� “INIT ��”
appears on the display while this is in progress�
7 Special displays
230 V power supply available
The symbol indicates that a 230 V power supply (mains
electricity) is available on the connected heater and/or
air conditioning system�
hot
Truma App with iNet Box
When a command is sent via the Truma App from a
mobile device, “APP” is displayed�
Infrared (IR) remote control (air conditioning
system)
When a command is sent via the infrared remote con-
trol of the air conditioning system, “IR” is displayed�
External control panel (CI-BUS)
When a command is sent via an external control panel
with CI-BUS, “CI” is displayed�

The CPplus CI BUS is a separate variant that is
equipped only in the factory�

Truma CP plus Specifications

General

Display	LCD
Power supply	12 V DC
Quiescent current consumption (at 12 V)	Approx. 5 mA
Temperature range	-15 °C to +60 °C
Protection class	IP20
Compatibility	Truma Combi heaters