Truma Saphir - Holder for Remote Control (Optional); 4�10 Accessories

SaphirProduct Description
10 EN
40090-00130 · 01 · 11/2023
4.9 Holder for remote control (optional)
There is a holder for the remote control that can be
mounted on a wall or cabinet in the vehicle (Fig. 17).
Fig. 17

Place the remote control into the holder or remove it
from above (Fig. 18).
TIMER
HOURS
MIN
RESET
ON
OFF
MODE
TEMP
AM
TIMER
HOURS
MIN
RESET
ON
OFF
MODE
TEMP
AM
Fig. 18
4.10 Accessories
There are various accessories for the air conditioning
system. These may be installed with the air conditioning
system, depending on the vehicle manufacturer.
4.10.1 Wall-mounted IR receiver
The remote control signals will be received by an
IRreceiver (Fig. 19).
The vehicle manufacturer installs the IRreceiver on an
inside wall or cabinet.
Fig. 19
4.10.2 Truma CP plus
The air conditioning system can be controlled with the
CP plus digital control panel (available as an option).
The CP plus control panel has an automatic climate
control function (ACC for primary heater), referred
to as AUTO mode in the CP plus menu. This automati-
cally controls the room temperature together with
the Truma Saphir air conditioning system and a
Truma Combi / Truma VarioHeat heater. In AUTO mode,
the air conditioning system will not be operated in
reverse cycle mode (heating).

A Truma Combi / Truma VarioHeat or Alde heater
must be installed to use the automatic climate con-
trol function on the Truma CP plus.
Fig. 20
The vehicle manufacturer installs the CP plus (Fig. 20) on
an inside wall, cabinet or storage compartment. It can
be visible or hidden.
Operation

See separate CP plus control panel operating in-
structions