Truma Saphir - Dehumidify; 6�10 Setting Fan Level; 6�11 Set Temperature Unit; 6�12 Set the Room Temperature

Saphir Operation
13EN
40090-00130 · 01 · 11/2023
Symbol Description
Cooling mode
Dehumidify mode
Heating mode
Automatic mode
Circulated air mode
When the room temperature that was selected using
the remote control is reached in cooling mode, the
compressor switches o. The circulated air fan contin-
ues to run in order to provide ventilation. If the room
temperature setting is exceeded, the device automati-
cally reverts to cooling mode.

An internal air temperature sensor prevents the com-
pressor from operating at temperatures of less than
61 °F (16 °C) during cooling.
When the room temperature that was selected using
the remote control is reached in heating mode, the
compressor switches o. The circulated air fan contin-
ues to run in order to provide ventilation. If the tempera-
ture drops below the selected room temperature, the
device automatically switches to heating mode.
In automatic mode the fan level is selected automatical-
ly depending on the dierence between selected and
actual room temperature.
6.9 Dehumidify
Dehumidify mode reduces humidity in the room. This
mode must be switched on and o manually and is
not controlled by room humidity level. The selected fan
level setting (low, medium, high) is deactivated and the
cooling mode activated.

Press the DEHUMIDIFY button.
The cooling mode and dehumidify icons are
shown on the display.
The green LED on the IR receiver flashes briefly.
The air conditioning system dehumidifies the room.
Press the button again to switch dehumidify mode o.
The air conditioning system is then operated with the
previous settings.
6.10 Setting fan level
The integrated air fan has three operating levels.
Symbol Description
Operating level: low
Operating level: medium
Operating level: high

Press the FAN button for the desired operating
level one or more times.
The fan’s desired operating level is shown on the
display.
The green LED on the IR receiver flashes briefly.
The desired operating level is set.

In the automatic mode, the FAN button has no
function.
6.11 Set temperature unit
The temperature on the display can be shown in
degrees Fahrenheit (°F) or Celsius (°C).

Press the TEMP and TEMP buttons at the
same time.
The temperature display changes between °F
and°C.
6.12 Set the room temperature
Use the “set temperature” buttons to set the required
room temperature with “+” and “–”.
The room temperature can be set in a range from
61°F (16°C) to 88°F (31°C) in steps of one degree.

Set the room temperature with the temperature
selection buttons, TEMP and TEMP .
The desired room temperature is shown on the
display.
The green LED on the IR receiver flashes briefly.
The desired room temperature is set.