Truma Saphir - 6�13 Set Clock; 6�14 Set Timer

SaphirOperation
14 EN
40090-00130 · 01 · 11/2023
6.13 Set clock
After replacing the battery, when changing to or from
daylight saving time, or when changing to a dierent
time zone, you have to set the time manually. If a timer
is active, the clock cannot be changed.

Press the TIME button.
The time is shown flashing on the display.

Set the current hour with the HOURS and
HOURS buttons.
Set the current minute with the MIN and
MIN buttons.

Press the TIME button again or wait approx.
10seconds.
The time is shown on the display.
The time is set.

The clock shows 12:00 pm at noon. At midnight it
shows 12:00 am.
6.14 Set timer
Two timers can be programmed.
•
Timer ON
The air conditioning system is o. The time set in the
timer determines when the air conditioning system
is switched on.
•
Timer OFF
The air conditioning system is on. The time set in the
timer determines when the air conditioning system
is switched o.
The timer can be set in a range of minimum 15 minutes
to maximum 24 hours. Times set in the timer of less
than 15 minutes are rounded up to 15 minutes.
Only one timer can be active at one time.
If a timer is active, all buttons except
ON/OFF , RESEND , TIMER and TIMER
have no function.
Times set in the timer are only sent to the air condi-
tioning system when the TIMER or TIMER
buttons have been pressed.
If the remote control goes to stand-by mode after ap-
prox. one minute and a timer is active, then, next to the
current time, the timer set time is shown on the display
with the corresponding timer ON or timer OFF icons.
When the timer has been programmed, no further
communication between the remote control and the
IRreceiver is required for the timer function to operate.
After programming, the remote control can be placed in
the holder or a drawer.
6.14.1 Program timer ON

Switch the air conditioning system on with the re-
mote control.
The air conditioning system runs with the previously
selected settings.

Set the desired operating mode and room tempera-
ture.

Press the TIMER button.
The timer ON icon is shown on the display.
The timer flashes.

Set the timer set time with the HOURS and
HOURS buttons.
Set the minutes with the MIN and MIN
buttons.

Confirm the setting with the TIMER button.
The time set in the timer is shown on the display
with the ON icon.
The time set in the timer is sent to the air condition-
ing system.
The green LED on the IR receiver flashes briefly.
The air conditioning system switches off and the
timer starts.

Wait approx. one minute while the remote control
goes to stand by. If the ON/OFF button is pressed
after timer programming, the air conditioning sys-
tem switches on again and the time set in the timer
is deleted.
When the time set for timer ON is reached, the air con-
ditioning system starts automatically with the previous-
ly selected settings.
6.14.2 Program timer OFF

Switch the air conditioning system on with the re-
mote control.
The air conditioning system runs with the previously
selected settings.

Set the desired operating mode and room tempera-
ture.

Press the TIMER button.
The timer OFF icon is shown on the display.
The timer flashes.

Set the timer set time with the HOURS and
HOURS buttons.
Set the minutes with the MIN and MIN
buttons.

Confirm the setting with the TIMER button.
The timer is shown on the display with the OFF icon.
The time set in the timer is sent to the air condition-
ing system.
The green LED on the IR receiver flashes briefly.
The air conditioning system runs with the previous
settings and the timer starts.