Saphir Cleaning
15EN
40090-00130 · 01 · 11/2023
Wait approx. one minute while the remote con-
trol goes to standby. If the ON/OFF button is
pressed after the timer programming, the air condi-
tioning system switches o again and the time set in
the timer is deleted.
When the time set for timer OFF is reached, the air con-
ditioning system switches o automatically.
6.14.3 Switch timer o
Press the TIMER or TIMER button again.
No timer is shown on the display.
The green LED on the IR receiver flashes briefly.
The timer is switched off.
6.15 Reset
The remote control settings can be reset to the factory
settings with the reset button.
Press the RESET button for 3 seconds, with a
pen, for example.
All icons flash briefly on the display. The remote control
switches o and the air conditioning system continues
to run unchanged. The next time the remote control is
activated, the default factory settings are set.
Factory settings:
•
Operating mode: Circulated air
•
Fan: Low
•
Time: 12:00 pm
•
Timer: O
•
Temperature: 72°F (22°C)
6.16 Resend
Sending settings to the air conditioning system can
fail if, for example, the remote control was not pointed
precisely at the IR receiver. In this case, the previously
selected settings can be sent again.
Press the RESEND button.
The send icon is shown briefly on the display.
The green LED on the IR receiver flashes briefly.
Settings are sent.
6.17 Set time format
The time on the display can be shown in the 12 or
24-hour format.
Press the TIMER and TIMER buttons at
the same time.
The time format changes between AM / PM and
24-hour format.
If a timer is activated, the timer must be switched o
via the remote control and programmed again.
7 Cleaning
NOTICE
Damage to the device caused by water
ingress through openings in vehicle under-
body
When cleaning the vehicle floor with a
high-pressure water blaster, avoid the area
around the supply air inlet and outlet.
Do not use any abrasive cleaning agents or sharp
objects. Use a soft, damp cloth to clean the air con-
ditioning system.
Do not use gasoline, diesel, solvent, chemical clean-
ing agents, alcohol, surfactants or plasticisers for
cleaning.
7.1 Clean supply air inlet and outlet
Keep the air conditioning system’s air inlets and air
outlets in the vehicle floor free of obstructions, e.g.
dirt or foliage, to ensure optimum performance and
optimum air flow rate. Otherwise, the function of the
air conditioning system will be adversely aected,
which may result in damage.
NOTICE
Water in the air conditioning system can
cause damage and malfunctions.
Do not clean the air conditioning system with
a hot/steam cleaner or high-pressure cleaner.
If cleaning the vehicle with a hot/steam
cleaner or high-pressure cleaner, do not
spray directly into the air conditioning sys-
tem’s openings.
When the vehicle underbody is being
cleaned, it must be ensured that no water
penetrates the openings in the base of the
device. Do not point a high-pressure water
jet, for example, directly into the openings.
7.2 Clean condensation trap
The condensation trap is under the vehicle floor. In
order to allow the condensation to drain away freely,
check unobstructed trap at regular intervals. Failure
to do this may allow condensation to penetrate the
vehicle.
Keep the air conditioning system’s condensation
traps in the floor free of obstructions, e.g. dirt or
foliage.
Keep the internal condensation trap clean.
To Next Page
Loading...
