Truma Saphir - Symbol Description

SaphirProduct Description
8 EN
40090-00130 · 01 · 11/2023
4.7.2 Top button panel
The top button panel includes the following functions
(Fig. 13):
MODE
TEMP
Saphir
MODE
TEMP
Fig. 13
Symbol Description
MODE
Select operating modes
•
Cooling
•
Heating
•
Automatic
•
Circulated air
FAN
Set fan operating level
•
Low
•
Medium
•
High
ON/OFF
TEMP +
TEMP -
Set temperature
•
61 - 88°F (16 – 31 °C)
•
In 1 °F (1 °C) steps
4.7.3 Bottom button panel
The bottom button panel includes the following func-
tions (Fig. 14):
MODE
TEMP
Saphir
RESET
MIN
HOURS
OFF
TIMER
ON
RESET
MIN
HOURS
OFF
TIMER
ON
Fig. 14
Symbol Description
TIME
Show / set time
NIGHT
Quiet mode
Remote control signals are sent with infrared waves to
the wall-mounted IRreceiver(Fig. 11).
There is an IR transmitter diode for this at the top of the
remote control.

To operate the air conditioning system, point the
remote control at the IR receiver.
TIMER
HOURS
MIN
RESET
ON
OFF
MODE
TEMP
Fig. 11
NOTICE
Do not cover the IR receiver.
The IR receiver must be exposed for fault-free
operation.

Do not place anything over the IR receiver.

Do not cover the IR receiver (e.g. with cur-
tains).
4.7.1 Button panels
The remote control has two button panels.
The buttons for the most important functions are on the
top button panel. They are always visible.
The buttons for advanced functions are on the bottom
button panel. This can be concealed with a cover.

Push the cover down (Fig. 12-1).
Bottom button panel is visible.

Push the cover up (Fig. 12-2).
Bottom button panel is concealed.
TIMER
HOURS
MIN
ON
OFF
MODE
TEMP
Saphir
MODE
TEMP
Saphir
Saphir
TIMER
HOURS
MIN
RESET
ON
OFF
MODE
TEMP
1
2
Fig. 12