Saphir Maintenance
17EN
40090-00130 · 01 · 11/2023
Then remove air filter from the front.
Reassemble the cleaned or changed air filter
(Fig. 24-1). Make sure that the air filter is correct-
ly aligned, as indicated by the arrow printed on it
(Fig. 24-3).
Re-fit the Saphir US lamellar insert (Fig. 24-1), clip
and sensor in the same position during assembly.
Re-fit the cold air ducts.
1
3
2
Fig. 24
NOTICE
Operating the device without a filter can
cause evaporator coil soiling, which can
have a detrimental eect on the perfor-
mance of the device!
When installing the air filter, the printed
arrows (Fig. 24-3) must point towards the
device – they indicate the circulated air flow
direction.
Never operate the device without a filter.
8.2 Insert/change batteries
The battery cover is on the rear of the remote control
(Fig. 25).
When removing the batteries, pairing between the
remote control and the air conditioning system is
maintained. The time and timer are not maintained.
Only use leakproof micro-batteries, type LR 3, AM4,
AAA, MN 2400 (1.5 V).
Observe the positive/negative positions when insert-
ing new batteries.
Then set the time and timer again.
Fig. 25
Low used batteries can leak and damage the remote
control.
Remove batteries when the remote control will not
be used for longer periods.
To Next Page
Loading...
