Tryax TY30-VS - Default Chapter; Table of Contents

To Next Page

To Previous Page

Tryax Limited Jubilee Trade Centre,Jubilee Road,Letchworth Garden City,Herts,SG6 1SP,UK

Phone +44(0) 1462-481295 Fax +44 (0) 1462-685275 www.tryax.com

Table of Contents

1. Safety Notes ........................................................................................................... 3

1.1 Safety Specification ........................................................................................................ 3

1.2 General Safety Notes ...................................................................................................... 3

1.3 Notes after Operation Stops .......................................................................................... 4

1.4 Notes on Handling Abnormal Status ............................................................................ 4

1.5 Maintenance Safety Notes ............................................................................................. 4

1.5.1 Routine Maintenance ....................................................................................... 4

1.6 Noise ................................................................................................................................ 5

2. Machine Brief Introduction ................................................................................. 6

2.1 Mechanical Specification ............................................................................................... 6

Machinery Outline Scheme Diagram .............................................................................

2.3 Assembly Drawing & Machine list ............................................................................... 8

2.4 Foundation Plan ............................................................................................................. 9

2.5 Mechanical Coordinate System .................................................................................. 10

2.6 Jaw Chuck size ............................................................................................................. 10

2.7 Tool Holder Dimension Drawing ................................................................................ 11

3. Move, Store and Install the Machine ................................................................ 11

3.1 Pre-installation Work

3.2 Unload and Moving the Machine ............................................................................... 13

3.3 Installation & Levelling

3.3.1 Machine Installation and Leveling ...................................................................

3.3.2 Install the Peripherals ................................................................................... 16

3.4 Power Requirement ..................................................................................................... 17

3.5 Compressed Air Source ............................................................................................... 18

3.6 Other Objects ............................................................................................................... 18

4. Pre-boot Preparation Works ............................................................................. 19

4.1 Pre-boot Check ............................................................................................................. 19

4.2 Oil-feed and Oil Types ................................................................................................. 20

4.2.1 Machine’s Oil-feed Points ............................................................................. 20

4.2.2 Referenced Machine Oils .............................................................................. 20

4.3 Chips Conveyor System ............................................................................................... 21

5. Machine Maintenance and Tuning ................................................................... 22

5.1 Maintenance Period ..................................................................................................... 22

5.1.1 Maintenance Interpretation .......................................................................... 22

5.1.2 Machine Regular Maintenance Frequency List .......................................... 22

5.1.3 Maintenance Check Sheet ............................................................................. 24

5.2 Soft jaw chuck Mechanism.......................................................................................... 26

5.3 Forced Auto Lubricator ............................................................................................... 26

6. Troubleshooting .................................................................................................. 29

6.1 Machine Troubleshooting ............................................................................................ 29

6.2 Quick-Wear Part List .................................................................................................. 30

7. Machine Parts List ............................................................................................. 31