4
1.3 Notes after Machining Operation Stops
1. Before opening the Access Doors, be sure that the chuck has stopped turning.
2. After the dry-cutting process is complete and before removing the workpiece, be sure
to put on safety gloves (to avoid skin-burn).
1.4 Notes on Handling Abnormal Status
1. Once an abnormal status occurs, press the emergency stop button immediately.
2. Before accessing Machine’s inner space, be sure that the main power supply is off and
the machine is stationary.
3. If in doubt, press the Emergency Stop Button and seek advice.
1.5 Maintenance Safety Notes
1. Before performing maintenance works, shut down main power supply and lock off.
2. Do not leave the machine in an exposed condition and un- attended..
3. After work is completed, do not leave any tool or part in the Machine or on the
operation panel.
4. Clean up the chip tank regularly and wear the correct hand-protection to prevent
allergy or cuts.
5. Keep the observation window clean. If the transparency is blurred, replace it
immediately.
1.5.1 Routine Maintenance
(1) Keep the Machine bed clean.
(2) Tune the indicating gauges (pneumatic and lube oil) to correct positions.
(3) Ensure that lube oil reaches the guide-way.
To Next Page
Loading...