Why is label feeding unstable on my TSC PEX-1121?
Unstable label feeding (skewing) when printing with your TSC printer can occur if the media guide doesn't touch the edge of the media. If the label moves to the right, move the label guide to the left. Conversely, if the label moves to the left, move the label guide to the right.
What to do if my TSC PEX-1121 Printer says 'No Ribbon'?
If your TSC printer shows a 'No Ribbon' error, first, check if you've run out of ribbon and supply a new roll. If the ribbon is not empty, ensure the ribbon is installed correctly. Please refer to the user’s manual to reinstall the ribbon.
What to do if my TSC Printer says 'No Paper'?
If your TSC printer indicates 'No Paper', first ensure that you haven't run out of labels and supply a new label roll. If the roll is not empty, check if the label is installed incorrectly. Finally, the gap/black mark sensor might not be calibrated; in that case, calibrate it.
How to fix no print on label issue on TSC PEX-1121 Printer?
If your TSC printer is not printing on the label, it could be due to incorrect loading of the label or ribbon. Follow the instructions for loading the media and ribbon. Also, verify that you are using the correct type of paper or ribbon, and check the ribbon-inked side.
Why does my TSC PEX-1121 Printer skip labels when printing?
Skipping labels during printing on your TSC printer can happen if the label size isn't specified correctly; ensure it is properly set up. The sensor sensitivity might also be a factor; calibrate the sensor using Auto Gap or Manual Gap options. Additionally, check if the media sensor is covered with dust and clear it with a blower.
What to do if my TSC PEX-1121 Printer has a paper jam?
Paper jams in your TSC printer can occur if the gap/black mark sensor isn't set properly; calibrate the media sensor. Ensure the label size is set correctly. Also, check for any labels stuck inside the print engine mechanism and remove them.
Why is the print quality poor on my TSC Printer?
Poor print quality on your TSC printer can stem from several factors. Ensure the ribbon and media are loaded correctly. Dust or adhesive on the print head can also cause this, so clean it. Check your print density settings and adjust the print speed. Inspect the printhead for damage by running a self-test to check the print head test pattern for missing dots. Verify that your ribbon and media are compatible. Adjust the printhead pressure if it's not set properly. Also, make sure the release lever latches the printhead correctly.
General| Print Technology | Thermal Transfer / Direct Thermal |
|---|---|
| Print Resolution | 203 dpi |
| Print Speed | 12 ips |
| Media Width | 25.4 mm - 114 mm |
| Media Thickness | 0.075 mm - 0.2 mm |
| Connectivity | USB, RS-232, Ethernet |
| Operating System Compatibility | Windows, Linux |
| Media Type | Continuous, Die-cut, Fanfold |
| Media Core Diameter | 76.2 mm (3") |
| Ribbon Width | 40 mm - 110 mm |
| Ribbon Length | 600 m |
| Ribbon Core Diameter | 25.4 mm (1") |
| Maximum Print Width | 104 mm |
| Interface | USB 2.0, RS-232, Ethernet |
| Power Supply | 100-240V AC, 50/60 Hz |
| Operating Temperature | 41°F - 104°F (5°C - 40°C) |
| Storage Temperature | -4°F - 140°F (-20°C - 60°C) |
| Humidity | 25% to 85% non-condensing |
To Next Page
