TSC TTP-2410M Pro - Loading Media in Rewind Liner with Label Mode (Option)

29
2.6.5 Loading Media in Rewind Liner with Label Mode (Option)
This mode can rewind the media including liner and label on the rewind spindle.
1. Open the printer right side cover.
2. Insert the supply holder guide and paper core into the internal rewind for 1” core label
roll.
Insert the supply holder guide, 3” label core adapter and paper core into the internal
rewind for 3” core label roll.
1” core label roll
3” core label roll
3. Insert media into the printer label spindle. Pull label roll leading edge forward through
the media guide bar, damper media sensor and place the label leading edge onto the
platen roller. (Please refer to section 2.6.1)
4. Then, pull approximately 650mm of label through the label redirect front panel.
5. Wrap the label onto the internal rewind spindle and stick the label onto the paper core.
Paper core
Supply holder
guide
Supply holder guide
Paper core
3” label core adapter