TSC TTP-2410M Pro - Service; Initialization

70
3.5 Service
Service
Initialization
Mileage Info.
Exit
This feature is used to restore printer settings to defaults and display printer mileage
information.
3.5.1 Initialization
Service 1/3
Initialization
Initializing …
>
Initialization
Mileage Info.
SELECT YES
Exit
MENU NO
The printer settings are restored to defaults as below once printer is initialized.
Note :
When printer initialization is done, please calibrate the gap or black mark sensor
before printing.
Parameter
Default setting
Speed
TTP-2410M Pro： 6 IPS (152 mm/sec)
TTP-346M Pro/246M Pro/344M Pro：4 IPS (101.6 mm/sec)
TTP-644M Pro： 3 IPS (76.2 mm/sec)
Density
8
Label width
4.00”(101.6mm)
Label height
4.00”(101.6mm)
Sensor type
Gap sensor
Gap setting
0.12”(3.0mm)
Print direction
0
Reference point
0,0(upper left corner)
Offset
0
Print mode
Batch mode
Serial port settings
9600 bps, none parity, 8 data bits, 1 stop bit
Code page
850
Country code
001
Clear flash memory
No
Shift X
0
Shift Y
0