TSC TTP-2410M Pro - Diagnostics; Print Config

67
3.3 Diagnostics
Diagnostics
Exit
Print Config.
Dump Mode
Rotate Cutter
3.3.1 Print Config.
This feature is used to print current printer configuration to the label. On the
sconfiguration printout, there is a print head test pattern, which is useful for checking if
there is any dot damage on the print head heater element.
Diagnostics 1/4
Self Test …
Printing …
>
Print Config.
1/1
Dump Mode
Rotate Cutter
Self-test printout
Printer model name & Main board firmware version
Printer serial number
Printed mileage
Main board firmware checksum
Serial port setting
Code page
Country code
Print speed
Print darkness
Label size (width, height)
Black mark or gap size (vertical gap, offset)
Sensor sensitivity
Ethernet settings information (option)
File management information
Print head test pattern