TSC TTP-2410M Pro - Page 45

40
Cutter Batch
Cut the label once at the end of the printing job.
Note: If printing from enclosed software/driver, the software/driver will send
out the command, which will overwrite the setting set from the front
panel.
3.1.1-1.5 Offset:
This option is used to fine tune media stop location. Press the button to
move the cursor from left digit to right digit, and press the button to set the
value from “+” to “-” or “0” to “9”. Press the button to set the value into
printer. Press key to cancel the setting and return to the previous menu.
The default value is +000.
Note: If printing from enclosed software/driver, the software/driver will send
out the OFFSET command, which will overwrite the setting set from
the front panel.
3.1.1-1.6 Shift X & Shift Y:
This option is used to fine tune print position. Press the button to move
the cursor from left digit to right digit, and press the button to set the value
from “+” to “-” or “0” to “9”. Press the button to set the value into printer.
Press key to cancel the setting and return to the previous menu. The
default value is +000.
Note: If printing from enclosed software/driver, the software/driver will send
out the SHIFT command, which will overwrite the setting set from the
front panel.
Print Setup 5/12
Direction
Print Mode
>
Offset
Offset
+000
Print Setup 7/12
Offset
Shift X
>
Shift Y
Shift Y
+000